Jeweled Tree multicard ECompleted by Peggy Stogdill

There are so many options with this kit. For this one, I decided to make a 5"x7" card, so I resized the files to 7" high, then printed sheets 2, 3 and 4 on matte photo paper (I didn't use sheet 1 for this card).

Since the gold card I was using was wider than the topper, I added a strip of multicolored glitter tape, leaving a narrow border of the gold card showing on the right side, then attached the topper with dst. (I removed the rosebud because it hung over the edge too far, but replaced it closer in under the leaf next to it).

I cut the gold portion of the insert from sheet 2 and centered it on the inside right page, attaching it with dst.

Cut out the large decoupage element from sheet 3 with detail scissors and a craft knife (removing the rose bud and a few of the background leaves) then carefully attached it with thin foam pads. I added a final layer of decoupage flowers from sheet 4, using the flowers and a few focal leaves, and attached it with silicone gel.