Christmas Wishes - Hexegon Trifold Card

Main card and decoupage printed onto 200gsm gloss paper, backing sheet printed directly onto main card, envelope printed onto silk paper.

Decoupage mounted using foam squares.

Main card and decoupage printed onto 200gsm gloss paper, backing sheet printed directly onto main card, envelope printed onto silk paper.

Decoupage mounted using foam squares.

I printed the main card front and the decoupage on to 160gsm card, the rest on to paper. I glued the backing sheet on to the card front, then cut them out together. Note, the horizontal cut along top and bottom of the centre section is all one long cut, so using the trimmer for this rather than scissors is a useful option.

All this section, and all parts of the decoupage, had a dark pen (mostly dark green) run round the edges before assembly.

The wreath decoupage is very fiddly to fussy-cut if you try to do every leaf, and I was lazy: I cut the edges back so that no white was left, relying on the lower level to supply the detail.

All decoupage was mounted on foam pads.

The envelope was assembled with a glue tape pen.

The to/from label was mounted on the back with a glue tape pen.

I printed the main card front and the decoupage on to 160gsm card, the rest on to paper. I glued the backing sheet on to the card front, then cut them out together. Note, the horizontal cut along top and bottom of the centre section is all one long cut, so using the trimmer for this rather than scissors is a useful option.

All this section, and all parts of the decoupage, had a dark pen (mostly dark green) run round the edges before assembly.

The wreath decoupage is very fiddly to fussy-cut if you try to do every leaf, and I was lazy: I cut the edges back so that no white was left, relying on the lower level to supply the detail.

All decoupage was mounted on foam pads.

The envelope was assembled with a glue tape pen.

The to/from label was mounted on the back with a glue tape pen.

I printed the main card front and the decoupage on to 160gsm card, the rest on to paper. I glued the backing sheet on to the card front, then cut them out together. Note, the horizontal cut along top and bottom of the centre section is all one long cut, so using the trimmer for this rather than scissors is a useful option.

All this section, and all parts of the decoupage, had a dark pen (mostly dark green) run round the edges before assembly.

The wreath decoupage is very fiddly to fussy-cut if you try to do every leaf, and I was lazy: I cut the edges back so that no white was left, relying on the lower level to supply the detail.

All decoupage was mounted on foam pads.

The envelope was assembled with a glue tape pen.

The to/from label was mounted on the back with a glue tape pen.