Set of 3 ~ Baby Boy Teddy Bear Mini Kit

I chose to use the hot wire balloon in this set. I made it with 110 lb cardstock and I printed a few layers so that I could make it a 3D card.

The two layers behind the bear I put foam tape between each of them to give them some height. I then printed and cut out the main image to create the different layers, again using foam tape. I used glitter on most of the card and a bit of clear glitter brush on a few areas. I also added some half pearls.

I printed the plain frame from the set to use on the inside and left it plain. The card measures approximately 5 x 6.5. Great set to work with and lots of fun/