3D Little Cupcake Shop Treat or Favour Box Mini KitCompleted by Shelagh E Osborn Wright

I printed the 2 sheets of the mini kit on smooth card and cut them out,scoring where indicated. I made up the inner box as shown, no glue needed,very simple. I put some goodies inside before closing.

I added DST to the base of the cupcake "shop" and centred the box on this. I folded up the sides,adding a pink satin ribbon to the top of one side with DST(so that it could be hung up or carried), then added non permanent DST to the top to close,so that it could be opened easily to get to the little goodies inside.

I also added a few embellishments to the cupcakes. This is a lovely little novelty treat box, great for little (or not so little) girls parties.