Wizard Of Oz 3D Shelf Card KitCompleted by Margaret McCartney

I printed the base of the card onto 250gsm card then fed it back through the printer to print the backing paper on the reverse then I cut it out.

I did the same for the shelf.

I printed each panel first onto 250gsm card and again I fed these back through the printer to print the backing paper onto the reverse.

I printed the panels again onto 280gsm photographic paper and cut out only the figures and I added these to each panel using thin foam tape.

I cut the slots where indicated and put each panel through the slots as instructed. I added the greeting using thin foam tape.