Exploding Box w/ Secret Gift Box Mothers Day 2020
The box is about 4 1/2" wide and 2 1/4" tall. When the lid is pulled off the 3 layers open up to reveal a secret gift box in the middle.
I do glue the 3 layers to each other, but let the secret gift box be loose so it can be picked up to take the lid off.
The secret gift box measures about 1 3/4 square and 1 inch tall. Besides putting a small gift within you could put a message in it leading to another gift. This includes 3 sentiment panels.
One of them is blank so you can use your own message, therefore this can be more than just a Mother's Day gift box.
The sentiment panels fit nicely on the bottom of the outside of the main box. Also included are two different gift tags. This includes decoupage, but you can make it without the decoupage if you are in a hurry or don't want it.
Photographs from the Community
Beautiful project with great instructions! I followed the written instructions to print the background on the next 5 pages, using regular white cardstock. I used scissors, a craft knife, DST, and a bit of craft glue.
For the embellishments I used double stick foam tape and added some glitter to the bottom layer before adding the dimensionals.
Everything fit together very easily by following instructions to cut off all the border print (put there so no white would be visible).
Beautiful project with great instructions! I followed the written instructions to print the background on the next 5 pages, using regular white cardstock. I used scissors, a craft knife, DST, and a bit of craft glue.
For the embellishments I used double stick foam tape and added some glitter to the bottom layer before adding the dimensionals.
Everything fit together very easily by following instructions to cut off all the border print (put there so no white would be visible).
Beautiful project with great instructions! I followed the written instructions to print the background on the next 5 pages, using regular white cardstock. I used scissors, a craft knife, DST, and a bit of craft glue.
For the embellishments I used double stick foam tape and added some glitter to the bottom layer before adding the dimensionals.
Everything fit together very easily by following instructions to cut off all the border print (put there so no white would be visible).