3D Open Front Easel Kit - Saw ThisCompleted by Carolyn Norris

The design was printed on quality cardstock, the decoupage was done with foam pads, and the easel was adhered together with double sided tape.

It is important that the cardstock be heavy, in order for the easel to stand straight.

If you do not have thick cardstock, I recommend you adhere two sheets together to give it the required strength.

I copied and cut out the wrench and screws a second time. I used foam pads for the screws and placed them along the easel stop line to give the aperture frame a bit more to catch on to.

I placed the wrenches on both sides of the aperture frame.

This is an easy to make, male easel card that is suitable for many occasions.