Snowflake Princess Party Small Cupcake/Cakepop StandsCompleted by Shelagh E Osborn Wright

I printed the visible parts of the approx six inch stand onto Hunkydory adorable scorable card .I cut out the parts and drew round onto strong grey board as advised, cut this out and glued the parts together as shown. Full instructions are included. There are three different stands in the kit, each a different size and design. I used good quality glue stick throughout. This pretty design makes into a sturdy stand

using a firm centre layer. I havent glued the top ,as I shall need to store it flat. it is gorgeous for any little girls party or for displaying at a craft fair. There are lots more lovely designs of papercrafting available in the snowflake princess range.