3D Liz's Flowers Gift Box Card Kit with 3D DecoupageCompleted by Margaret McCartney

I printed the backing paper onto 2 sheets of white card then fed it back through the printer to print first the front of the card and then the back of the card onto the reverse side.

I then printed all the sheets onto good quality 255gsm photographic paper and cut everything out. Using strong double sided tape I assembled the card, box and sleeve following the easy instructions that come with the design.

I attached the inside pocket using strong double sided tape.

I added the front and back panels that I had printed onto the photographic paper to the back and front of the card using double sided tape.

I added the spines and flaps also using double sided tape. I assembled the decoupage on the front of the card using thin foam tape. I added the greeting to the front of the card using thin foam tape.

I put a gift into the box and slid it into the sleeve then tied it with the ribbon as instructed.

A beautiful card and gift rolled into one and very easy to make too.