Deck the Halls, Christmas Decoration CardCompleted by Hazel Pepper

I printed sheet 1 three times, sheet 2 at 19cm x 21.5cm sized, and sheet 3 four times, with two of them mirrored.

I did this so the top can be decoupaged and the baubles 3D.

I stuck the base of the top and three of the baubles onto card for rigidity, and then cut all the pieces out.

I made the baubles by folding the pieces in half and stuck them back to back, and then onto the base piece.

I punched a hole in the top, threaded ribbon through and glued a small bow on the top.

I decoupage the top, using 1mm foam pads, and then attached the baubles on the back, sticking down firmly. I mounted the paper to a 24.5cm x 21cm card blank. I used removable tabs to stick the decoration onto the card blank.