Cacti 3D Square Card KitCompleted by Wendy Howroyd

I printed the three cacti in pots layer and the 3D cacti sections onto 16ogsm card and cut them all out.

I then folded the cacti sections in half and glued them together to form the 3D effect and stuck them onto the three cacti in pots layer, then I stuck it all onto the topper using foam pads.

I used one of the greeting rectangles and stuck this on the topper using foam pads too. I printed a personalised greeting on the insert using Photoshop, and stuck this inside.

It's all ready to be folded flat and popped in an envelope to the recipient, for them to pull up the flattened sections for the 3D effect.

It's quite simple to make up but it looks very effective.