Puttin on the Glitz Explosion Card KitCompleted by Doreen Bell

I printed the back and front onto 200gsm card as it needs to stand up. I printed the other sheets onto 160gsm card. I scored where indicated and cut out all the pieces.

I glued the back to the front using wet glue. made up the exploding centre piece and attached to the inside of the card making sure it was central.

I attached the front picture using DST then built up the layers and decoupage using 3D foam pads. I finished off using gems and glitter pens to enhance the lovely bright picture. I made up the envelope using DST.

I went on to make a 6x6 card using just the main picture and made up the belt to go round it as can be seen in the photos below.