3D Meerkats Animated Moveable Decoupage Card KitCompleted by Hazel Pepper

I printed the sheets from this kit onto Photo paper. I cut out the pieces, mounting the main image, the base decoupage and the two mechanism pieces from sheet 02, onto card, and re-cut them.

This is to make sure that the card is sturdy enough to move.

I cut the card base, sheet 01, in half and mounted the front panel onto an A5 card blank. I followed the instructions to make the card, using 2mm foam tape to hold the panel down, and 1mm foam pads to add the decoupage.