3D Snowflake Dangler and Card Front
Based on my own original 3D embellishment design, this time as a dangler card. Make up the 3D embellishment as per my tutorial, using just the 7 pieces on the right hand side of the sheet.
Cut out the aperture in the card front.
Use the 8th element from the centre of the aperture as the backer, adding your dangler ribbon or cord before adhering to your 3D embellishment.
Then just attach the dangler 3D embellishment in the aperture of your card. Some decoupage is also included to add that finishing touch. If you like this why don't you go and check out all my other original 3D embellishment designs. Just click on my name and have a browse.
Photographs from the Community (1)
After cutting out all the parts, the base print was put on cardstock using DST. The centre decal was cut out leaving the aperture for the hanging snowflaked. This was assebled using a gluestick and attached using a fine peel off.
Dimensional paint was used on the base print, and a silver snowflake border applied. These cards give such dimension and make them unique.
