Rupert with Presents Stamp
Thank you so much for your support All Stamps are created at 300 DPI and are approximately 1200 pixels at the longest end.
Photographs from the Community (1)
I printed this digi-stamp out onto 300gsm Super Smooth cardstock at smaller than the size provided. I then coloured it in using my ProMarkers. I cut it out using a circle scissors.
I took an A4 sheet of star embossed white cardstock and trimmed it then scored twice to create an easel card.
The piece cut off was trimmed to make the stopper. I rounded the corners on the base card and stopper with a paper punch. I went round all the pieces with a yellow ProMarker that I'd used when colouring in the image.
I attached the circular topper to the easel card using fingerlift tape with a little glue gel for extra strength because of the embossing.
I used 2mm deep, double sided, foam tape to attach the stopper. I finished off by attaching yellow sticky back faux pearls. I've not put on a greeting yet as I don't know what language it will be needed in but there's plenty of room on the stopper for this.
