Standing Horse Stamp

I printed the digital stamp out onto Super Smooth cardstock at much smaller than the size it came at. I then coloured it in using four shades of brown ProMarkers. After that I cut it out using a die.

I printed out background cup374737_846 onto the same type of cardstock, cut out a panel from it and then put it through my manual embossing machine in a wood effect embossing folder.

After that I used the open edge of a scissors to roughen up the edges. To construct the card I used an A5 white base card that came pre-cut with a large deckle edge. Around this I wrapped a sheet of gold pearlescent vellum.

The embossed background panel was stuck to this. I cut two panels with different sized dies from the same set, one out of brown pearlescent cardstock and one out of gold, linen effect, cardstock.

These were put behind the coloured in digi panel.

I then just added three little die cut flowers lef over from another project at the bottom of the die-cut panels.