Bumper Nitwitivity Easel Draw Card + Box + 3D FlowerCompleted by Margaret McCartney

I printed the bulk of the design onto good quality white card then fed it back through the printer to print the backing paper onto the reverse.

I then cut these out. I assembled the easel and the box drawers following the instructions included with the kit.

I assembled the main box also following the instructions. I used strong double sided tape to do this. I printed the sheets with the images again onto 255gsm photographic paper and cut out the pictures and attached them to the design using strong double sided tape.

This gives a nice glossy finish to the easel and the box.

I am not too good with 3D flowers so I assembled the two flowers and leaves and attached these to the easel using a brad from my craft box and thin foam tape.

The easel and drawers fit nicely into the box. A cute design and great fun to make up.