Anchor with Rope Backing Paper

I printed the background onto 120gsm Super Smooth white paper at half size and pyramage topper cup363264_1051 onto 250gsm Super Smooth white cardstock.

I cut everything out.

I put a piece of twine around the panel of the background and stuck it onto a 7" x 10" Kraft base card using finger-lift tape and I went around the edge using a ProMarker.

I also put a double wiggly line around the outside of the base card as well. I then attached the base layer of the topper using fingerlift tape and built up a few of the layers using 1mm deep, double sided, foam tape.