Square 'silver Metallic Frame' Card Front or Insert
A Card Front with a lovely subtle linen texture topped with a with a beautiful 'Silver Metallic Embossed Frame' effect for all your crafting needs
This Card Base is is approx 5" in size with matching backing paper/card back on the same sheet, just cut out and fold in half to create your card blank.
This design can easily be resized to suit your project requirements and folded the other way will work equally well as an insert too!
There is a backing paper set to match this design too.
This sheet is also available as part of a Bumper Value Pack.
This design is great for female birthday cards and male birthday cards but is also suitable for lots of occasions including Anniversary card, Mothers Day card, Invitations, rak and swap cards etc
This sheet will mix match and coordinate with all my Neutrals downloads too.
Photographs from the Community
I printed this sheet out onto 300gsm Super Smooth white cardstock, cut it out, scored it using my Hougie Board and then folded it in half. I printed out digi-stamp cup435840_117 at smaller than the size provided onto the same type of cardstock, coloured it in using my ProMarkers, and then cut it out using my circle scissors but doing an "out of the box" technique so that the top of the branches were left attached and then cut around using a scissors. This digi-stamp panel was then attached to the card using 2mm deep, double sided, foam tape.
The neutral colour of this card means that it will go with many different colours of topper and is suitable for a male card.