Woven Ribbon Card - Tall SantaCompleted by Craft Box Designs

I printed the sheeet onto glossy photo paper and cut out all the pieces. I cut out the white semi circles using a craft knife. I took two contrasting ribbons and threaded them through the slots in the image then stuck them at the bottom on the reverse using tape.

I made up my decoupage using foam pads and attached it to the image. I covered the front of an A5 sized card with green holographic card, then using a mixture of double sided tape and tacky glue I attached my image to the front of the card.

I used the glue because I didn't have any tape narrow enough to go down the right side beside the apertures.

I stuck on a gold peel off greeting and finally I added a bow to the top of the aperture row.

I'm very happy with the result and I think if I'd had wider ribbon it would have looked even better.