Pansy on Butterfly Lace - Tunnel Topper
A really easy Tunnel quick card topper design that is just under 10 x 10 cm just cut out the tunnel layers and add using foam tape or silicone to create a stunning 3d effect that draws your eye to the centre.
Three small matching toppers that are approx 6 x 6 cm are also included on the sheet, these can be used on their own or inside or on the back of your card, and would also make great gift tags too! Or why not include your contact details on the back of one the toppers, and pop in with your finished card ... for future orders!
This design is also available in other coordinating colourways/designs and together they would make a great set of cards to sell at craft fairs etc.
This sheet will also make great shaker cards too!!
Photographs from the Community
I made an easel card from an A4 sheet of white linen card. Printed the cup sheet onto glossy photo paper and cut out. I took the cup sheet into a graphics programe and made backing sheets and a tag to support the card.
I layered a square of backing paper onto a square of silver mirri board and a smaller square of silver mirri board onto the backing sheet leaving a whole border of pansies around the edge.
I then assembled the decoupage and attached to the centre of the front half of the card. I stuck a piece of backing sheet to the bottom of the card leaving the white border on and attached the tag.
Some small crystal butterflies were added to each side of the main picture along with a couple of silver peel off corners and some pale yellow gems in the centre of the three large pansies.I really enjoyed making this card.
I didn't add a message as it could be used for many occasions and could be added later.