Poppies Fancy Bracket 7x5 Spiral Edge Stacker
I have designed this card front in my spiral edge stacker concept to create a spiral edge around the card front.This is a 7inch x 5inch square card front so it will fit the A5 cards if you add a backing paper.
Simply cut out the base image and attach to your card or project flat, then cut out the edges starting at number 1.
Glue your edges using a 3D glue or foam pads, and attach to the base image going around the outside, each edge overlaps the last, this will build up the outside edge into a 3D decoupage effect.
As you glue the edges you are going around the card in a spiral effect.
Photographs from the Community
I used pink card. I made a mountain fold at one side of the card. I made up the spiral edge stacker and mat and layered onto red glitter card which was then placed in the centre of my own backing paper onto the main part of the card.
I made a smaller version of this design so that I could place it on the large mountain fold. On the small fold I attached some embellishments. I added my own sentiment and placed beads in each corner of the main part of the card.