Oriental Garden Ladies Spiral Edge Stacker Card Front
I have designed this new concept to create a spiral edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach
to your card or project flat, then cut out the edges starting at number 1. Glue your edges using
a 3D glue or foam pads, and attach to the base image going around the outside, each edge
overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you
glue the edges you are going around the card in a spiral effect.
Photographs from the Community
The sheet was printed onto glossy white photo paper and the pieces cut out, carefully putting the numbers lightly in pencil behind each piece so that I knew which order they were to be attached.
I took an A5 card, made from an A4 sheet of Centura Pearl Snow White card and attached a piece of textured gold card, cut at an angle with a wavy cutter, to the left hand side. I stuck the main image directly towards the top of the card. I then followed the pictorial instructions to build up the spiral edge stacker, sticking each piece in place with 1mm deep double sided foam tape. I finished the card off by sticking some very small, sticky back, faul deep red gems along the edge of the gold pannel and the top right corner.
I've left enough room on the card for a greeting, suitable for the recipient, to be added once I know who's to receive it.