Christmas Feeding Robins Spiral Edge Stacker Card Front
I have designed this new concept to create a spiral edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach
to your card or project flat, then cut out the edges starting at number 1. Glue your edges using
a 3D glue or foam pads, and attach to the base image going around the outside, each edge
overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you
glue the edges you are going around the card in a spiral effect.
Photographs from the Community
I cut out the elements from the sheet, writing the numbers on the back for assistance later. I mounted the base onto a 13cm x 13cm card blank. I followed the instructions to make the spiral stacker, first laying it out flat to find out what goes where.
I then added 2mm foam pads to all of the layers and stuck it together.