Christmas Candle 3 Spiral Edge Stacker Card Front
I have designed this new concept to create a spiral edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach
to your card or project flat, then cut out the edges starting at number 1. Glue your edges using
a 3D glue or foam pads, and attach to the base image going around the outside, each edge
overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you
glue the edges you are going around the card in a spiral effect.
Photographs from the Community
The image was printed out onto 180grm everyday, glossy photo paper. Red ribbon was threaded around a 5 x 7 card, tied in a bow at the spine and secured with silicon.
The main image was matted with double sided sticky tape. 2mm foam pads were used for the layers.
Finally, a gold holographic peel-off was added. This is a great concept which works well and is very easy to assemble.