My Christmas Tree Spiral Edge Stacker Card Front
I have designed this new concept to create a spiral edge stacker around a card front.
This is a 5inch x 5inch square card front, and you simply cut out the base image and attach
to your card or project flat, then cut out the edges starting at number 1. Glue your edges using
a 3D glue or foam pads, and attach to the base image going around the outside, each edge
overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you
glue the edges you are going around the card in a spiral effect.
Photographs from the Community
The image was printed out onto 180grm everyday, glossy photo paper. A piece of red mirri card was trimmed to make a backing and was matted to a 5 x 7 card with double sided sticky tape. 2mm foam pads were used for the layers.
A red holographic Christmas greeting was added. Finally, using glitter glue, white glitter was added to give some sparkle. This is very easy to assemble and the new concept works very well, giving depth to the image.