Kitty

The sheet was printed onto super smooth white card and the layers cut out. I made two cards using the sheet. The first (insert photo) was made by sticking the base image layer directly onto a square card with a gold embossed border.

I then put a fine peeloff around the image and finished the card off using some gold ribbon. The second card was made as an easel card by taking a cream square card and folding the front in half.

I stuck the backing element on the bottom half of the card and went round it with gold border peeloffs.

I stuck the largest image of Kitty to the centre of the card, being careful only to stick on the backing half.

I also went round this with the same peeloffs. I took a piece of the ribbon element, 5 cat faces length and again went around with gold peeloffs. I stuck this to the inside of the card some 2cm from the edge using 2mm deep double sided foam tape.

I stuck gold corner peeloffs to the corners inside and each of the four corners of the outside of the card.

I built up three layers of the Kitty image using 1mm deep double sided foam tape.