Floating Deckchair

I printed the sheet out onto Super Smooth white card and cut out the pieces. I took a card base of linen textured green card and put one of the frame layers over it and drew around the inside.

I then used ruler and craft knife to cut out the centre, making sure to cut a mm further out than the line.

I glued a frame to the front. I printed one of the two backgrounds on sheet cup8717 to the right size to fit inside the back of the card, trimmed it and stuck it in place.

I took a narrow strip of acetate and stuck this to the back of one of the deckchair pieces and used glue gel to stick the other side behind it. the other end of the acetate strip was stuck behind the front frame before the other frame was stuck around to cover the back.

When the card is open and standing on a mantel the deckchair is just floating in mid air.