Black Carnations Spiral Edge Stacker 8x8inch Card Front Kit
I have designed this new concept as a kit to create a spiral edge stacker around a card front.
This is a 8inch x 8inch square card front, and you simply cut out the base image and attach
to your card or project flat, then cut out the edges starting at number 1. Glue your edges using
a 3D glue or foam pads, and attach to the base image going around the outside, each edge
overlaps the last, this will build up the outside edge into a 3D decoupage effect. As you
glue the edges you are going around the card in a spiral effect. This kit will create 3 layers for you.
Photographs from the Community
I cut out the elements from the sheets, writing the numbers on the back for assistance later. I mounted the base onto a 20cm x 20cm black mat and that onto a 21cm x 21cm card blank.
I followed the instructions to make the spiral stacker, first laying it out flat to find out what goes where.
I then added 2mm foam pads to all of the layers and stuck it together