Lace Wedding Couple A4 Swirvey Side Stacker Kit
This is a new design that I have created. This kit is for making a A4 card topper with a swirvey side stacker design based on
my original swirvey side stackers. This kit enables you to make a great design but with only a few very simple steps.
You get 6 sheets to make a 6 layer picture using 3D foam or
silicone glue. If you do not want to make a A4 card you could always make a 3D picture.
Photographs from the Community
I printed the kit onto sheets of small(4x6) size card stock.I cut out each piece on each sheet in the kit.
I covered the base card stock with wedding backing paper. I also used wedding backing paper to cover the inside of the card as well.
I used foam mounting pads to layer each piece of both the left and right sides of the card. I used colored pencils to brighten and sharpen the bridge and groom image on the card. I punched two holes in the left side of the card and then ran small sheer ecru colored ribbon through the holes to make a small bow.
I glued a small pearl button in the center of the bow.