Gingerbread House 3D Easel Card
Scrumptious gingerbread house decorated with candy canes, lollipops, chocolate buttons, chocolate logs, sugar hearts and gingerbread elves - all topped off with delicious gooey icing!
3D pop-up figures include rudolph, santa and santa's sleigh. Lots of decoupage for the house and the pop-up figures is also included, but looks great either with or without it.
Assembly instructions are shown on the sheets.
The kit contains the following 5 sheets:
1. Base Bottom & 3DPop-ups
2. Card Base
3. Panel & Decoupage
4. Envelope Front
5. Envelope Back
Photographs from the Community
I printed the card elements out onto super smooth card and cut out. i scored and folded where indicated to form the easel card base and cut the slits where indicated..
I built up the decoupage using foam pads, before attaching the house to the easel back with ds tape and placing the pop up elements through the slits and securing with tape as instructed.
I then stuck the card base in place again using ds tape. I finished off bu adding white soft stuff around the edge to create a snowy feel. i love this card.
I printed the sheets onto high quality card paper. I cut out all the elements. Using double side adhesive tape I attached house decoupages to the card according the instruction. I made figures of Santa, his gifts and Xmas tree (I replaced the deer - sorry).
Then I glued base and front sides of the card and added few glittering. I also made the special envelope for this "paper construction" - not just card.