Christmas for You Snow A5 Locket Card Front
I have designed this card and 3D locket based on a design I have made previously.
The card front measures A5 and this is simply cut out and glued to the the front of any card you have, then you cut out the locket part and attach the end part that has part of the base picture on, this wants to be attached to the matching part of the picture, use a permanent glue/adhesive for that part so it is well glued on.
Then fold the middle section intowards the picture and the locket front the opposite way, these want to be back to back with each other, glue them back to back and you have the lock part completed.
Your card will look as if you have taken ages to make and will impress your friends.
Photographs from the Community
This card made up nicely with little effort.
I followed the easy directions. I printed the pattern on good glossy card stock and cut out the pieces. Using a nice embossed polka dot pink card stock I adhered the pieces with double back tape. The locket closure was first glued together front to back and the small end piece was matched to the inside of the locket and adhered. I also used a small amount of shiny clear tape to reinforce the area of the closure front and back as it will surely be opened and closed a lot.
Lastly I added the foil greeting and snow onto the front and a nice insert to the inside. EZ and very pretty!