Fishing Rod Backing Paper

I printed the sheet off at half size onto 120gsm good quality paper and cut two panels out of it, one with only a single fishing rod on it.

I prepared an A5 base card by sticking on a panel of brown Basal cardstock and then added the largerst backing panel.

I printed out and coloured in digi-stamp cup437878_1141 and after cutting it out I matted this and the small backing panel onto blue Basal cardstock before trimming to leave a border.

These were then stuck to the card front using 2mm deep, double sided, foam tape.

I finished the card off by putting matching insert cup546885_1051 inside the card.