Square 'silver Metallic Frame' Card Front or Insert
A Card Front with a lovely subtle linen texture topped with a with a beautiful 'Silver Metallic Embossed Frame' effect for all your crafting needs
This Card Base is is approx 5" in size with matching backing paper/card back on the same sheet, just cut out and fold in half to create your card blank.
This design can easily be resized to suit your project requirements and folded the other way will work equally well as an insert too!
There is a backing paper set to match this design too.
This sheet is also available as part of a Bumper Value Pack.
This design is great for female birthday cards and male birthday cards but is also suitable for lots of occasions including Anniversary card, Mothers Day card, Invitations, rak and swap cards etc
This sheet will mix match and coordinate with all my Sorbet downloads too.
Photographs from the Community
I printed this sheet out onto 300gsm Super Smooth white cardstock and measured the central circular area. I then printed out cup430967_117 onto the same type of cardstock at a size that would fit.
I trimmed this card front, scored it using my Hougie Board, and then folded it in half to make my base card.
After colouring in the digi-stamp I cut out a circle from it, went round the edge with a silver metalic marker and stuck it to the front of the card using 2mm deep, double sided, foam tape.
I finished the card off by embelishing using two different shades of sticky back faux pearls. I've not put on a greeting yet as I don't know what language the card will be needed in.